Specify your Cisco Meraki as a RADIUS client resource In AuthPoint, resources are the applications and services that your users connect to.This secret key is used to communicate with the RADIUS server (AuthPoint Gateway).īefore AuthPoint can receive authentication requests from your Cisco Meraki, you must: In the Secret text box, enter the shared secret to use for RADIUS authentication.In the Host text box, enter the IP address of the AuthPoint Gateway.From the Authentication drop-down list, select RADIUS.

In the Shared secret text box, enter shared secret to use for the L2TP/IPSEC VPN connection.In the Custom nameservers text box, enter your DNS server IP address.In some environments, you might select use umbrella. From the DNS server drop-down list, select Specify nameservers.In the Subnet text box, enter a new subnet for the client VPN.From the Client VPN server drop-down list, select Enable.Select Security & SD-WAN > Configure > Client VPN.From the Network drop-down list, select your Meraki device.You have installed and configured AuthPoint Gateway (see About Gateways)Ĭomplete the steps in this section to configure the Cisco Meraki MX64.Your Meraki device is managed by Meraki Cloud.This diagram shows an overview of the configuration required for RADIUS authentication.īefore you begin these procedures, make sure that:

The hardware and software used in this guide include:Ĭisco Meraki Configuration for RADIUS AuthenticationĪuthPoint communicates with various cloud-based services and service providers with the RADIUS protocol.

Meraki vpn mac